Frames are manufactured using 12’ wide x 8’ tall rails with a powder coated finish and base plates of galvanized steel and are available in sizes ranging from 6’ 0” in width up to 15’ 0” in width and from 6’ 0” in height up to 12’ 0” in height. The bases weigh approximately 50# and create a very stable temporary solution. B-35 Laserguard is installed over the frame like an upside down pillowcase. Each pillowcase has a 4”-6” wing of fabric so as to allow the wings to overlap and eliminate any light gap that might occur between frames. The frames can be set up as a U shape, a circle or a square, and can be assembled and disassembled with no tools.
B-35 Laserguard fabric is manufactured to "confine stray laser plume", so should a stray beam hit the curtain, non-hazardous smoke may appear and the area may glow, thus indicating the stray beam is present. Please refer to our test results page for detailed information.
We are the only LASER SAFETY company that has a medical consultant on staff to address the unique requirements of a Dental Office, Medical Office, Laser Clinic or Hospital. Use our contact form to find the best method of setting up Laser Safety Curtains so that they provide safety, in a practical, cost efficient manner.
Beamstop'r Laser Barriers is now offering the option of a BROAD-SPECTRUM ANTI-MICROBIAL treatment for your laser barriers. We are currently the only manufacturer of laser safety barriers that is offering this affordable solution for a clean room or a hospital. This treatment kills dangerous microbes and deactivates spores such as C. difficile and Bacillus anthrax. Surface contamination, mold, mildew, air pollutants and odors are constantly reduced by our eco-friendly and sustainable treatment. There are no environmental hazards.
GSA CONTRACT# GS07F0339Y